Garden answer youtube.
Diy gutter planter.
The front and back of each gutter piece will have 2 holes.
Measure 12 inches of.
Tie a knot at one end of the 10 foot rope.
For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Start by drilling the bottom holes using your drill and 3 8inch bit.
Garden answer youtube.
This will lock each segment along the suspension wire.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.